Table of Contents
Advertisement
EPB electric parking brake
Refit the brake discs (
Adjust the EPB electric parking brake (
Refit the rear bumper (
Refit the wheels (
D2.01).
Replacing the EPB electric parking brake Bowden cables
Tightening torque
Fastening EPB Bowden cable - rear hub carrier
Fastening brake pad sensor ground cable
Disable the EPB electric parking brake Autohold function (
Remove the rear bumper (
D3.03).
D3.07).
E3.04).
Screw
Nut
E3.04).
Press on the two indicated fastener tabs and fit the
left hand EPB Bowden cable sheath (D) into the
relevant mounting bracket.
Attach the end (2) of the left hand EPB Bowden
cable (D) to the EPB linkage bracket (A).
Refit the clip (1) in the relevant seat on the EPB
linkage bracket (A).
Check that the disc rotates freely without
impediment. If not, adjust the adjuster pin to
achieve the optimum position.
Adjustment is also possible with the disc installed,
inserting a screwdriver through the holes (F).
Turn the adjuster pin to separate the brake shoes
until a slight resistance is felt; then turn the
toothed sleeve by one turn in the opposite
direction to close them slightly.
8 Nm
6 Nm
D3.07).
Page 10 of 17
Nm
Class
B
B
Advertisement
Table of Contents
