Table of Contents
Advertisement
Suspension arms
Fit the four shims (5) in the relevant seats, pushing
down completely onto the stud bolts and
ensuring that they are perfectly perpendicular to
the horizontal axis of the Flanblocs.
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm fastener
nuts, complete with relative washers, each
time they are removed.
Replacement is NOT necessary if the nuts are
loosened only.
Tighten the four nuts indicated fastening the lower
arm (A) in the following tightening order: (a), (b),
(c), (d).
Tightening torque
Nut (pretightening)
Nut
Check that the yellow reference markings are
correctly aligned: the markings on the stud bolts
and the markings on the Flanbloc eyebolts must
be aligned.
Page 10 of 24
Nm
Class
9 Nm
B
60 Nm
A
Advertisement
Table of Contents
