Table of Contents
Advertisement
Complete suspension
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the four nuts fastening the lower
arm (C), retrieving the four shims (8), in the
following order: (a), (b), (c), (d).
Check that the yellow reference markings are
correctly aligned: the marking on the threaded
rods and the marking on the Flanbloc eyebolts
must be aligned.
Only the nut must turn, the threaded rod must
remain in its original position.
If the markings on the threaded rods and eyebolts
are not correctly aligned after loosening the arm
fastener nuts (even if only on one threaded rod),
a ROL (Red On Line) must be opened, attaching
adequate photographic documentation, and
contact the Ferrari Help Desk.
If the markings on the threaded rods and eyebolts
are correctly aligned after loosening the arm
fastener nuts, completely undo and remove the
four arm fastener nuts in the order given for the
previous operation.
Check again that the yellow reference markings are
correctly aligned: the markings on the threaded
rods and the markings on the Flanbloc eyebolts
must be aligned.
Page 4 of 25
Advertisement
Table of Contents
