Table of Contents
Advertisement
Brake servo - Pump
Ensure that the retainer clip (5) is installed correctly
on the brake servo.
Working from the luggage compartment, fit the
brake servo (A), complete with pump, in the
relative seat on the firewall.
Working from underneath the driver side of the
dashboard, align the linkage (6) in the relative
seat on the brake servo (A).
Tighten the four nuts indicated in a cross pattern.
Tightening torque
Nut
Depress the brake pedal fully to engage the linkage
(6) onto the brake servo (A).
Release the brake pedal and ensure that it is
effectively attached to the linkage.
The fluid contained in the brake system is
harmful in the event of contact with the eyes
or skin.
In the event of contact with brake fluid, rinse the
affected area immediately with plenty of
running water.
Brake fluid may also damage paintwork.
Fit the unions (2) for the pipes (1) in the respective
seats on the pump and tighten.
Tightening torque
Union
Connect the vacuum pipe (4) to the brake servo (A).
Connect the pipes (3) to the brake pump and fasten
with the indicated clamps.
Page 3 of 4
Nm
Class
20 Nm
B
Nm
Class
16 Nm
B
Advertisement
Table of Contents
