Table of Contents
Advertisement
Shock absorbers
Remove upper arm from the relative stud bolts, retrieving the four washers, and slightly turn it toward the front
of the vehicle.
Remove the shock absorber from the relative seat.
Check that the yellow reference markings are
correctly aligned: the marking on the stud bolts
and the marking on the Flanbloc eyebolts must
be aligned.
If the markings on the stud bolts and eyebolts are
not correctly aligned after loosening the arm
fastener nuts (even if only on one stud bolt), a
ROL (Red On Line) must be opened, attaching
adequate photographic documentation, and
contact the Ferrari Help Desk.
If the markings on the stud bolts and eyebolts are
correctly aligned after loosening the arm fastener
nuts, completely undo and remove the four arm
fastener nuts in the order given for the previous
operation.
Move the shock absorber aside to facilitate the
operation.
Check again that the yellow reference markings are
correctly aligned: the markings on the stud bolts
and the markings on the Flanbloc eyebolts must
be aligned.
Holding the pin (3) fastening the shock absorber to
the lower arm still, undo the nut (4) and retrieve
the relative washer.
Support the weight of the shock absorber (A) and
remove the pin (3) from the relative seat.
Page 3 of 16
Advertisement
Table of Contents
