Water pump
Fill the engine lubrication system (
Fill the cooling system (
Refit the from timing cover (
A3.01).
A3.07).
B2.05).
On the workbench, replace and lubricate the two O-
rings (1) on the pump, taking particular care not
to damage the rings or the seal recesses.
Ensure that the two O-rings (1) are installed
correctly and are NOT twisted.
Fit the water pump (A) in the relative seat on the
front timing cover, taking care not to pinch the O-
rings.
Prefit the pump, bringing the mating surfaces into
contact and aligning the fastener holes, then
tighten the two screws indicated.
Tightening torque
Screw
Page 2 of 2
Nm
Class
10 ÷ 12 Nm
A