Table of Contents
Advertisement
Axle shafts
Fit the axle shaft in the hub carrier bearing.
Tilt the hub carrier inward to bring the axle shaft and the differential flange together.
Fit new cable retainer clamps if the previous clamps were cut.
Apply three even and regularly spaced circular
beads of AREXONS SYSTEM 56A01 - HIGH
STRENGTH RETAINING COMPOUND.
Support the weight of the rear suspension
adequately, pretighten the nut (6) with a
tightening angle of 80°, and then fully tighten,
fitting the relative pin fastening the upper arm (D)
to the hub carrier (C).
Tightening torque
Nut
Pretighten the nut (5) with a tightening angle of 70°,
then fully tighten, fitting the relative pin fastening
the toe-in tie-rod (B) to the hub carrier (C).
Tightening torque
Nut
Page 4 of 6
Nm
Class
90 Nm
A
Nm
Class
80 Nm
A
Advertisement
Table of Contents
