Table of Contents
Advertisement
Brake pads
Tightening torque
Fastening central pin on front brake pads
Further separate the calliper pistons with the tool (FACOM DF.6).
Refit the wheels (
D2.01).
Reconnect the battery (
In case of replacement only. Bed in the CCM pads (
Removing the rear brake pads
Disconnect the battery (
Remove the wheels (
Screw
F2.01).
F2.01).
D2.01).
27 ÷ 33 Nm
Fit the brake pads (A) in the relative seats.
Install the pin (6).
Tighten the screw (5).
Tightening torque
Screw
Fit the lower pin (4) in the relative seat, tapping into
place with a suitable mallet and punch.
Fit the spring (3) in the relative seat.
Fit the upper pin (2) in the relative seat, tapping into
place with a suitable mallet and punch.
Sliding pad wear sensor cable inside rigid brake
fluid pipe connected to brake calliper, tighten a
new cable tie in the indicated point.
Sliding it under ABS sensor cable, connect pad
wear sensor connector (1), and secure it to the
relative mounting bracket, so as it is pointing
toward rear side.
Apply new cable ties in the positions indicated.
D3.04).
Page 2 of 5
Nm
Class
0
Nm
Class
27 ÷ 33 Nm
0
Advertisement
Table of Contents
