Table of Contents
Advertisement
EPB electric parking brake
After manually releasing the electric parking brake, at the subsequent Key-on, the EPB node
registers a "fault" and the symbol shown aside is displayed on the left hand TFT display,
together with the message "Parking Brake system revision. Go to dealer".
CAUTION
For safety reasons, it is IMPERATIVE that the following indications are followed correctly.
The parking brake will return to normal functionality, however, the vehicle must still be taken to a Ferrari
service centre to calibrate the system and delete any errors from the failure memory. The system must be
calibrated for safety reasons.
Removing the EPB electric parking brake shoes
The following procedure is for removing the rear right hand wheel brake shoes.
With the exception of the specific steps indicated, the procedure for removing the rear left hand wheel brake
shoes is the same.
Remove the articulated wrench, p/n 261346, for
releasing the electric parking brake, from the tool
bag.
Fit the articulated wrench, p/n 261346, into the
relative hole underneath the slotted cap (1) on
the right hand rear wheelhouse, and turn
clockwise to loosen the parking brake cables
completely and release the grip of the shoes on
the rear discs.
The wrench must be turned approximately 50
times to completely release the parking brake;
the brake will begin to release after
approximately 20 turns.
Page 4 of 17
Advertisement
Table of Contents
