Table of Contents
Advertisement
Brake pads
Brake 16 times from 80 Km/h to 20 Km/h with constant pressure on the brake pedal and without activating
the ABS system.
Leave the brake system to cool for approximately 120 seconds.
Brake 16 times from 120 Km/h to 20 Km/h with constant pressure on the brake pedal and without activating
the ABS system.
Leave the system to cool for 180 seconds.
The ABS system must be triggered during the last set of braking runs.
Brake AT LEAST 5 times from 120 Km/h to 0 Km/h (vehicle completely stopped), causing the ABS system
to activate.
Allow the brake system to cool completely before using the vehicle again after the bedding-in procedure
to ensure maximum braking efficacy.
As soon as you notice an increase in brake pedal travel, stop the car and wait for the brake system to cool
completely.
For vehicles intended for TRACK use
Brake 16 times from 80 Km/h to 20 Km/h with constant pressure on the brake pedal and without activating
the ABS system.
Leave the brake system to cool for approximately 120 seconds.
Brake 16 times from 120 Km/h to 20 Km/h with constant pressure on the brake pedal and without activating
the ABS system.
Leave the system to cool for 180 seconds.
The ABS system must be triggered during the last set of braking runs.
Brake AT LEAST 5 times from 160 Km/h to 0 Km/h (vehicle completely stopped), causing the ABS system
to activate.
Allow the brake system to cool completely before using the vehicle again after the bedding-in procedure
to ensure maximum braking efficacy.
As soon as you notice an increase in brake pedal travel, stop the car and wait for the brake system to cool
completely.
Page 5 of 5
Advertisement
Table of Contents
