Table of Contents
Advertisement
Axle shafts
Tighten the six screws (3) fastening the axle shaft
(A) to the differential flange, fitting the three
shims (4).
Tightening torque
Screw
Tighten the ring nut (2) fastening the axle shaft to
the hub carrier bearing.
Tightening torque
Nut
Loosen the ring nut (2) and retighten.
Tightening torque
Nut
Use a punch and mallet to caulk (1) the ring nut (2).
Press on the two indicated fastener tabs and fit the
right hand EPB Bowden cable sheath (9) in the
relative mounting bracket.
Move the EPB equaliser (7) to the left.
Page 5 of 6
Nm
Class
78 Nm
A
Nm
Class
275 Nm
A
Nm
Class
275 Nm
A
Advertisement
Table of Contents
