Table of Contents
Advertisement
Tyres and rims
Remove the rim from the machine and put carefully in a safe place.
If the tyre is not to be refitted immediately, refit the valve core and cap.
Remove the tyre pressure sensor (
Proceed as follows if removal is necessary.
Checking wheel rims
Ensure that the entire edge of the bead is outside
the rim and completely visible. If this is not the
case, the bead may be damaged.
If the bead does not slide easily into the groove,
lubricate the contact area.
Turn the wheel clockwise.
Position the inflation valve (A) at 12 o'clock.
Fit the lever (5) on the tool (4).
Lift the tyre.
Take care not to damage the sensor when
inserting the tyre lever (5).
Position the lower bead of the tyre on the tool (4),
using the lever (5).
Turn the wheel clockwise.
D2.03).
Page 7 of 11
Advertisement
Table of Contents
