Table of Contents
Advertisement
Refitting the complete engine
Clean the area surrounding the fastener point for
the clutch hydraulic system oil pipes thoroughly
using a suitable degreaser that does not leave
residue.
Remove the plugs fitted previously on the oil pipes.
Replace the O-rings on the clutch hydraulic system
oil pipes (4) and fit into the relevant seats.
Fit the fork (3) on the clutch hydraulic system oil
pipes and fasten to the gearbox by tightening the
screw indicated.
Tightening torque
Screw
Fit and fasten the heat shield (2), tightening the
screw indicated.
FROM Ass.ly No. 92290
Fit and fasten the heat shield (2), tightening the
screw indicated.
Page 29 of 30
Nm
Class
20 Nm
A
Advertisement
Table of Contents
