Table of Contents
Advertisement
Suspension arms
Remove the lower rear suspension arm from its relevant seat.
Refitting rear suspension lower arms
Tightening torque
Spherical tie-rod - lower arm
Fastening lower arm to chassis
Fastening lower arm to hub carrier
Fastening shock absorber to lower arm
The replacement arm is supplied complete with Flanbloc.
Check that the yellow reference markings are
correctly aligned: the marking on the stud bolts
and the marking on the Flanbloc eyebolts must
be aligned.
Only the nut must turn, the stud bolt must remain
in its original position.
If the markings on the stud bolts and Flanbloc
eyebolts are not correctly aligned after loosening
the arm fastener nuts (even if only on one stud
bolt), a ROL (Red On Line) must be opened,
attaching adequate photographic documentation,
and contact the Ferrari Help Desk.
If the markings on the stud bolts and Flanbloc
eyebolts are correctly aligned after loosening the
arm fastener nuts, completely undo and remove
the four arm fastener nuts in the order given for
the previous operation.
Check again that the yellow reference markings are
correctly aligned: the markings on the stud bolts
and the markings on the Flanbloc eyebolts must
be aligned.
Spherical tie-rod
Nut (pretightening)
Nut
Nut
Screw
Page 17 of 24
Nm
Class
50 Nm
B
9 Nm
B
60 Nm
A
205 Nm
A
80 Nm
A
Advertisement
Table of Contents
