Table of Contents
Advertisement
3.3 Replacing the complete vehicle flank
13. Sand the weld beads joining the vehicle flank with
the upper casting of the front sill pillar.
Caution!
Take the utmost care not to damage the die-
cast joints.
Check that the front sill pillar die-cast joints are
free from cracks.
If any damage is noted, replace the sill (see
chapter 3.5).
14. Use a 13 mm wrench to remove the 2 M8 screws
from the front pillar (interior of vehicle).
NOTE!
When removing the screws, take the utmost
care not to let them fall into the front door pillar.
Copyright ©
2010
13
14
Advertisement
Table of Contents
