Table of Contents
Advertisement
06) Check that heater circuit is off.
07) Start engine at idle speed and wait for 5 minutes.
08) Keep engine running at idle speed, check level and, if necessary, top up until MAX level.
09) Take and keep engine at 2000 rpm for 30 seconds.
10) Take and keep engine at idle speed for 30 seconds.
11) Take and keep engine at 2000 rpm for 30 seconds.
12) Take and keep engine at idle speed for 30 seconds.
13) Take and keep engine at 2000 rpm for 30 seconds.
14) Take and keep engine at idle speed for 2 minutes (or until radiators electric fans are enabled).
15) Keep engine running at idle speed, check level and, if necessary, top up until MAX level.
16) Take and keep engine at 2000 rpm for 1 minute.
17) Take and keep engine at idle speed for 30 seconds.
18) Open heater circuit selecting the max. temperature of air conditioning system for both "zones".
19) Take and keep engine at 3000 rpm for 1 minute.
20) Take and keep engine at idle speed for 2 minutes.
21) Keep engine running at idle speed, check level and, if necessary, top up until MAX level.
22) Take and keep engine at 3000 rpm for 1 minute.
23) Take and keep engine at idle speed for 1 minute.
24) Take and keep engine at 3000 rpm for 1 minute.
25) Take and keep engine at idle speed for 1 minute.
26) Close heater circuit.
27) Turn engine off.
28) Allow engine to cool until water temperature is 40 - 45 °C (1h and 30'- 2 hours) with expansion tank plug
open.
Refit the engine compartment cosmetic shields (
29) If necessary, top up until reaching the point
where fluid level in header tank is 60 mm from
filler plug top (1) (MAX level).
Tighten the cap (1).
E3.13).
Advertisement
Table of Contents
