Table of Contents
Advertisement
Suspension arms
Remove upper arm of rear suspension from the relative seat, retrieving the two washers from the relative stud
bolts.
Holding the pin (1) still, undo the nut (2) and retrieve
the relevant washers.
Remove the pin (1) from the relevant seat.
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the two nuts indicated fastening the
upper arm (A) to the chassis.
Check that the yellow reference markings are
correctly aligned: the marking on the stud bolts
and the marking on the Flanbloc eyebolts must
be aligned.
If the markings on the stud bolts and Flanbloc
eyebolts are not correctly aligned after loosening
the arm fastener nuts (even if only on one stud
bolt), a ROL (Red On Line) must be opened,
attaching adequate photographic documentation,
and contact the Ferrari Help Desk.
If the markings on the stud bolts and Flanbloc
eyebolts are correctly aligned after loosening the
arm fastener nuts, completely undo and remove
the two arm fastener nuts in the order given for
the previous operation.
Move the shock absorber aside to facilitate the
operation.
Check again that the yellow reference markings are
correctly aligned: the markings on the stud bolts
and the markings on the Flanbloc eyebolts must
be aligned.
Page 12 of 24
Advertisement
Table of Contents
