Table of Contents
Advertisement
Stabiliser bars - Tie-rods
Tightening torque
Fastening rear stabiliser bar to chassis
Products to use: AREXONS SYSTEM 52A43 -
MEDIUM STRENGTH THREAD LOCK
Fastening rear stabiliser bar to tie-rod
Screw
Nut
Apply 1 ml of DuPont Lubricants Krytox® 205
GPL Standard Grade Grease grease in a
uniform film over the entire inner surface and on
the lateral surfaces (contact surfaces only) of the
bushings.
Apply a uniform film of DuPont Lubricants
Krytox® 205 GPL Standard Grade Grease
grease to the outer diameter of the bar and the
shoulders of the bushings.
Fit the bushings in the relative seats on the
stabiliser bar, ensuring that the bushings are
oriented correctly (see notches on bushings).
Fit the rear stabiliser bar (A) in the relative seat on
the chassis, with the notch (3) nearest to the
outer edge on the bushing is facing upward.
Fit the retainer plate on the bushing and tighten the
indicated screws.
Tightening torque
Screw
Page 2 of 10
Nm
Class
60 Nm
B
50 Nm
B
Nm
Class
60 Nm
B
Advertisement
Table of Contents
