Table of Contents
Advertisement
Removing the complete engine
Move the oil pipes of both systems aside carefully, taking care not to twist or damage them, so that they do
not hinder the removal of the gearbox.
Undo the screws indicated fastening the retainers
on the pillory blocks holding the clutch hydraulic
system oil pipes (4) and the gear oil pipes (6).
Clean the area surrounding the gear oil pipe
fastener point thoroughly with a suitable
degreaser that does not leave residue.
Place a container for collecting the gear oil under
the pipes.
Undo the screw indicated fastening the fork (5) on
the gear oil pipes.
Pour the oil drained from the system into a
container and seal it. DO NOT dispose of
used oil in the environment.
Disconnect the gear oil pipes (6) from the gearbox
and plug immediately.
Release the oil pipes from the mounting bracket (7)
and remove the bracket from the gearbox.
Remove the clamp fastening the gearbox wiring
harness, undoing the screw indicated, and
disconnect the three connectors (8).
Move the gearbox wiring harness out of the way so
that it does not hinder the removal of the
gearbox.
Remove the indicated clamp and separate the
respective pneumatic actuator system pipes (10).
Page 19 of 26
Advertisement
Table of Contents
