Pressure switch/thermostat
Print Exit
B6.04
Pressure switch/thermostat
Replacing the pressure switch/thermostat
Tightening torque
Fastening hose union to thermostat
Drain the cooling system (
Remove the engine inspection hatch (
Refit the engine inspection hatch (
Fill the cooling system (
Screw collar
B6.07).
E4.06).
Tightening torque
Screw collar
E4.06).
A3.07).
Nm
4 Nm
Loosen the clamp (1) and detach the pipe (2) from the
pressure switch/thermostat (A).
Undo the screws indicated, remove the pressure
switch/thermostat (A) and replace.
Fit the pressure switch/thermostat (A) in the relative seat and
fasten by tightening the screws indicated.
Fit the pipe (2), positioning the notch correctly, and fasten by
tightening screw collar (1).
Page 1 of 1
Class
B
Nm
Class
4 Nm
B