Table of Contents
Advertisement
Removing the complete engine
UP TO Ass.ly No. 90801
Remove the clamp (20) on the pipe retainer pillory
block, undoing the screws indicated.
UP TO Ass.ly No. 90801
Disconnect the power steering system pipe (8),
removing the indicated clamp.
Disconnect the quick connector (9) of the brake
servo vacuum pipe (19).
Place a container under the clamp (10).
Loosen the clamp (10) and disconnect the pipe (11)
from the front timing cover.
Pour the fluid drained from the system into a
container and seal it. DO NOT DISPOSE OF
USED FLUID IN THE ENVIRONMENT.
Allow all the fluid to drain completely.
Place a container under the clamp (12).
Loosen the clamp (12) and disconnect the pipe (13)
from the pressure switch/thermostat.
Pour the fluid drained from the system into a
container and seal it. DO NOT DISPOSE OF
USED FLUID IN THE ENVIRONMENT.
Allow all the fluid to drain completely.
Detach the brake servo vacuum pipe (19) from the
pillory block.
Page 6 of 26
Advertisement
Table of Contents
