Table of Contents
Advertisement
3.6 Replacing the rear firewall and mountings
5. Remove the structural rivets fastening the rear
firewall (engine area).
NOTE!
Retrieve all the rivets, using a magnet if
necessary, as any remaining rivets will cause
noise when the vehicle is in use.
6. Remove the structural fastener rivets joining the
firewall, the fuel tank cross-member and the sill
connector cross-member.
NOTE!
Retrieve all the rivets, using a magnet if
necessary, as any remaining rivets will cause
noise when the vehicle is in use.
Copyright ©
2010
5
6
6
5
6
Advertisement
Table of Contents
