Table of Contents
Advertisement
2.7 Replacing the shock tower
15. Remove the structural rivets (1 upper rivet and 3
lateral rivets on inner side) fastening the upper
diagonal brace to the shock tower.
NOTE!
Retrieve all the rivets, using a magnet if
necessary, as any remaining rivets will cause
noise when the vehicle is in use.
16. Grind the joint welds between the upper diagonal
brace and the shock tower.
NOTE!
Do not remove any other material from the
upper diagonal brace.
Copyright ©
2010
15
15
16
16
Advertisement
Table of Contents
