Table of Contents
Advertisement
Complete suspension
Remove the yellow reference markings made
during removal.
Using an indelible red marker pen or paint, make
reference markings on the threaded rods and
relative nuts and the eyebolts of the Flanblocs
fastening the lower arm.
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm fastener
nuts, complete with relative washers, each
time they are removed.
Replacement is NOT necessary if the nuts are
loosened only.
Tighten the two nuts indicated fastening the upper
arm (E) to the chassis.
Tightening torque
Nut (pretightening)
Nut
Check that the yellow reference markings are
correctly aligned: the markings on the threaded
rods and the markings on the Flanbloc eyebolts
must be aligned.
Page 21 of 25
Nm
Class
9 Nm
B
60 Nm
A
Advertisement
Table of Contents
