Table of Contents
Advertisement
EPB electric parking brake
Fit the lower spring (11) in the respective seat,
pushing towards the brake shoes and then
turning the spring.
Fit the upper spring (10) in the respective seat,
pushing towards the brake shoes and then
turning the spring.
Fit the adjuster pin (9) in its seat.
Attach the spring (8) to both brake shoes.
Check that there is a sufficient gap between the
outer surfaces of the shoes to install the brake
disc without scuffing.
If the gap is insufficient, to adjust the gap between
the outer surfaces of the shoes and allow
installation of the brake disc without friction, turn
the toothed sleeve on the adjuster pin (9) using a
suitable screwdriver.
Attach the eyebolt (6) on the right hand EPB
Bowden cable (B) to the fork (7) inside the hub
carrier.
Page 8 of 17
Advertisement
Table of Contents
