Table of Contents
Advertisement
Complete suspension
Remove the yellow reference markings made
during removal.
Using an indelible red marker pen or paint, make
reference markings on the threaded rods and
relative nuts and the eyebolts of the Flanblocs
fastening the upper arm.
Tighten the nut indicated fastening the stabiliser bar
(D) to the spherical tie-rod.
Tightening torque
Nut
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm fastener
nuts, complete with relative washers, each
time they are removed.
Replacement is NOT necessary if the nuts are
loosened only.
Tighten the two nuts indicated fastening the toe-in
tie-rod (C) to the chassis.
Tightening torque
Nut (pretightening)
Nut
Page 22 of 25
Nm
Class
50 Nm
B
Nm
Class
9 Nm
B
60 Nm
A
Advertisement
Table of Contents
