Table of Contents
Advertisement
Complete suspension
Fit the four shims (16) in the relevant seats, pushing
down completely onto the threaded rods and
ensuring that they are perfectly perpendicular to
the horizontal axis of the Flanblocs.
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm fastener
nuts, complete with relative washers, each
time they are removed.
Replacement is NOT necessary if the nuts are
loosened only.
Tighten the four nuts indicated fastening the lower
arm (F) to the chassis in the following tightening
order: (a), (b), (c), (d).
Tightening torque
Nut (pretightening)
Nut
Attach the tie-rod (15) for the NRRPS motion
sensor onto the lower arm (F).
Check that the yellow reference markings are
correctly aligned: the markings on the threaded
rods and the markings on the Flanbloc eyebolts
must be aligned.
Page 20 of 25
Nm
Class
9 Nm
B
60 Nm
A
Advertisement
Table of Contents
