Broadcast Messages - YASKAWA V1000 Technical Manual

Register No.
CPF Contents 1
bit 0 to 1
bit 2
bit 3
bit 4 to 5
bit 6
bit 7
00D0H
bit 8
bit 9 to A
bit B
bit C
bit D
bit E
bit F
CPF Contents 2
bit 0
bit 1
bit 2
bit 3
bit 4
00D1H
bit 5
bit 6
bit 7
bit 8
bit 9
bit A to F
Option Card Fault Contents
bit 0
bit 1
00D8H
bit 3
bit 4
bit 5 to F
00FBH
Output Current
<1> Units are determined by parameter o1-03.
<2> Display is in the following units: BA0001 to BA0018, 2A0001 to 2A0040, and 4A0001 to 4A0023: 0.01 A units.
2A0056 to 2A0069, 4A0031 to 4A0038: 0.1 A units.
<3> The communication error log is stored until the fault is reset.
<4> Depending on the motor used the correct motor pole number must be set to parameter E2-04, E4-04 or E5-05.
<5> Available in drive software versions PRG: 1011 and later.
u

Broadcast Messages

Data can be written from the master to all slave devices at the same time.
The slave address in a broadcast command message must be set to 00H. All slaves will receive the message, but will not
respond.
YASKAWA ELECTRIC SIEP C710606 16C YASKAWA AC Drive – V1000 Technical Manual
Reserved
A/D Conversion Error (CPF02)
PWM Data Fault (CPF03)
Reserved
Drive specification mismatch during Terminal Board or Control Board replacement (CPF06)
Terminal Board Communications Fault (CPF07)
EEPROM Serial Communications Fault (CPF08)
Reserved
RAM Fault (CPF11)
FLASH Memory Fault (CPF12)
Watchdog Circuit Exception (CPF13)
Control Circuit Fault (CPF14)
Reserved
Clock Fault (CPF16)
Timing Fault (CPF17)
Control Circuit Fault (CPF18)
Control Circuit Fault (CPF19)
Hardware fault at power up (CPF20)
Hardware fault at communication start up (CPF21)
A/D Conversion Fault (CPF22)
PWM Feedback Fault (CPF23)
Drive capacity signal fault (CPF24)
Terminal board is not properly connected (CPF25)
Reserved
Option Compatibility Error (oFA00)
Option not properly connected (oFA01)
Option Self-diagnostics Error (oFA03)
Option Flash Write Mode Error (oFA04)
Reserved
<2>
C.10 MEMOBUS/Modbus Data Table
Contents
C
425