Navigating The Drive And Programming Modes - YASKAWA V1000 Technical Manual

u

Navigating the Drive and Programming Modes

The drive is set to operate in Drive Mode when it is first powered up. Switch between display screens by using the
and keys.
Frequency Reference
Power Up
Drive Mode
Output Frequency Display
Output Current Display
Output Voltage Reference
Drive Mode
Programming
Mode
Frequency Reference
Drive Mode
YASKAWA ELECTRIC SIEP C710606 16C YASKAWA AC Drive – V1000 Technical Manual
This display screen allows the user to monitor and set the frequency reference while the
drive is running.
Note: The user can select items to display when the drive is first powered up by setting
parameter o1-02.
STOP
Default Setting
Forward/Reverse
Note: For applications that should not run in reverse (fans, pumps, etc.), set parameter
b1-04 = "1" to prohibit the motor from rotating in reverse. This sequence also puts the
STOP
drive in LOCAL mode.
Monitors the frequency output by the drive.
STOP
Monitors the output current of the drive.
STOP
Scroll through o1-01 (User Monitor Selection) until the desired contents appear.
(Default setting)
Refer to Parameter List on page 329
STOP
Monitor Display
Monitor parameters (U parameters) are displayed.
STOP
Verify Function
Lists all parameters that have been edited or changed from default settings.
to Verifying Parameter Changes: Verify Menu on page
STOP
A select list of parameters necessary to get the drive operational quickly.
Setup
The Setup Group within the Programming Mode on page
Note: Parameters to be displayed differ depending on the setting of A1-06 (Application
Preset).
STOP
Parameter Setting
Allows the user to access and edit all parameter settings.
on page
STOP
Auto-Tuning
Motor parameters are calculated and set automatically.
page
STOP
Returns to the frequency reference display screen.
STOP
4.3 The Drive and Programming Modes
Refer to The Drive and Programming Modes on page
: Motor rotates forward.
: Motor rotates in reverse.
Switching to reverse:
The LED is lit when
LOCAL is selected
Refer to Application Selection on page
329.
100.
82.
Refer
86.
Refer to
84.
94.
Refer to Parameter List
Refer to Auto-Tuning on
4
83