YASKAWA V1000 Technical Manual page 84

4.3 The Drive and Programming Modes
n Drive Mode Details
The following actions are possible in the Drive Mode:
• Run and stop the drive.
• Monitor the operation status of the drive (frequency reference, output frequency, output current, output voltage, etc.).
• View information on an alarm.
• View a history of alarms that have occurred.
Note: Select "Drive Mode" when running. The mode can be switched to any mode (program mode, etc.) other than drive mode while the
drive is stopped. However, the drive cannot be operated in other modes. Return the mode to "Drive Mode" after completing periodic
inspection.
Figure 4.4 illustrates changing the default frequency reference of F 0.00 (0 Hz) to F 6.00 (6 Hz) while in Drive Mode.
This example assumes the drive is set to LOCAL.
Frequency reference
display at power up
STOP
Press until the frequency
reference becomes 6 Hz
Note: The drive will not accept a frequency reference set value unless the ENTER key is pressed after the frequency reference is entered.
This feature prevents accidental setting of the frequency reference. By setting o2-05 (Frequency Reference Setting Method Selection)
to 1 (Enabled), the drive will accept the frequency reference while it is being adjusted on the digital operator.
n Programming Mode Details
The following actions are possible in the programming mode:
• Verify Function: Verify parameter setting changes from original default values.
• Setup Group: Access a list of commonly used parameters to simplify setup.
• Parameter Setting Mode: Access and edit all parameter settings.
• Auto-Tuning: Automatically calculates and sets motor parameters for Open Loop or PM Vector control to optimize the
drive for the motor characteristics.
The Setup Group within the Programming Mode
In Setup Group, the user can access the minimum group of parameters required to operate the application.
Note: Setup Group parameters are listed in
Note: Pressing ENTER from APPL navigates to the Application Preset setting display. When the set value is changed, the parameter is
changed to the optimum value for each application. It is set to 0 (General-purpose) prior to shipment.
on page 94.
Figure 4.5 illustrates the keys to press to enter the Setup Group.
In this example, the source of the frequency reference is changed from the control circuit terminals to the LED Operator
(i.e., b1-01 is changed from 1 to 0).
84
Press to select LOCAL
Figure 4.4 Setting the Frequency Reference while in Drive Mode
Table 4.4.
YASKAWA ELECTRIC SIEP C710606 16C YASKAWA AC Drive – V1000 Technical Manual
Press to select the
digit to the right
Refer to Application Selection