Setting 5: Compressor Application; Setting 6: Hoist Application - YASKAWA V1000 Technical Manual

4.6 Application Selection
No.
L8-38 Carrier Frequency Reduction
No.
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-04 Reverse Operation Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-02 Carrier Frequency Selection
d2-01 Frequency Reference Upper Limit
d2-02 Frequency Reference Lower Limit
u

Setting 5: Compressor Application

No.
A1-02 Control Method Selection
b1-04 Reverse Operation Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-01 Drive Duty Selection
E1-03 V/f Pattern Selection
L2-01 Momentary Power Loss Operation Selection
L3-04 Stall Prevention Selection during Deceleration
No.
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-04 Reverse Operation Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
u

Setting 6: Hoist Application

Note: 1. Read the instructions listed on page
2. Perform Auto-Tuning after selecting the Hoist Application Preset.
3. If UL3 appears on the operator display after Auto-Tuning is complete, set L6-01 to 0 to repeat the Auto-Tuning process.
No.
A1-02 Control Method Selection
b1-01 Frequency Reference Selection 1
b6-01 Dwell Reference at Start
b6-02 Dwell Time at Start
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-01 Drive Duty Selection
C6-02 Carrier Frequency Selection
d1-01 Frequency Reference 1
d1-02 Frequency Reference 2
d1-03 Frequency Reference 3
E1-03 V/f Pattern Selection
96
Parameter Name
Table 4.12 HVAC Fan: User Parameters (A2-01 to A2-16)
Parameter Name
Table 4.13 Compressor: Parameter Settings
Parameter Name
Table 4.14 Compressor: User Parameters (A2-01 to A2-16):
Parameter Name
97 when using Hoist Application Preset
Table 4.15 Hoist: Parameters and Settings
Parameter Name
2: Enabled across entire frequency range.
No.
E1-03 V/f Pattern Selection
E1-04 Maximum Output Frequency
E2-01 Motor Rated Current
H3-11 Terminal A2 Gain Setting
H3-12 Terminal A2 Bias Setting
L2-01 Momentary Power Loss Operation Selection
L8-03 Overheat Pre-Alarm Operation Selection
o4-12 kWh Monitor Initialization
0: V/f Control
1: Reverse Prohibited
5.0 s
5.0 s
0: Heavy Duty
0FH
1: Enabled
1: Enabled
No.
E1-03 V/f Pattern Selection
E1-07 Middle Output Frequency
E1-08 Middle Output Frequency Voltage
E2-01 Motor Rated Current
− −
2: Open Loop Vector Control
0: Operator
3.0 Hz
0.3 s
3.0 s
3.0 s
0: Heavy Duty
2: 5 kHz
6.0 Hz
30.0 Hz
60.0 Hz
0FH
YASKAWA ELECTRIC SIEP C710606 16C YASKAWA AC Drive – V1000 Technical Manual
Default Setting
Parameter Name
Default Setting
Parameter Name
Default Setting