Protective Covers; Protective Covers; Ip20 Front And Bottom Cover Removal And Installation - YASKAWA V1000 Technical Manual

3.5

Protective Covers

Follow the procedure below to remove the protective covers before wiring the drive and to reattach the covers after wiring
is complete.
u

IP20 Front and Bottom Cover Removal and Installation

n
Removing the Protective Covers
1.
Loosen the screw that locks the front cover in place to remove.
2.
Apply pressure to the tabs on each side of the terminal cover. Pull the terminal cover away from the drive while
pushing in on the tabs to pull the cover free.
n Reattaching the Protective Covers
Properly connect all wiring and route power wiring away from control signal wiring. Reattach all protective covers when
wiring is complete. Apply only a small amount of pressure to lock the cover back into place.
YASKAWA ELECTRIC SIEP C710606 16C YASKAWA AC Drive – V1000 Technical Manual
Figure 3.6 Remove the Front Cover on an IP20 Drive
Figure 3.7 Remove the Terminal Cover on an IP20 Drive
Figure 3.8 Reattach the Protective Covers on an IP20 Drive

3.5 Protective Covers

53
3