Ipv4 Setup - ZyXEL Communications MSC1000G User Manual

Chapter 14 Sys Screens

14.5 IPv4 Setup

Click Sys > IP Setup from the navigation panel to open the following screen. Use this screen to
configure the system and management IP addresses and subnet masks.
Figure 392 IPv4 Setup
The following table describes the labels in this screen.
Table 305 IPv4 Setup
LABEL
Inband
IP Address
IP Mask
VID
Outband
IP Address
IP Mask
Default Gateway
Apply
Cancel
570
192.168.1.3
DESCRIPTION
These fields configure in-band management settings. In-band management refers to
accessing the management interface through a network port (not the management port).
Enter the in-band management IPv4 address for the system in dotted decimal notation
(for example 1.2.3.4).
Enter the in-band management IPv4 subnet mask for the system in dotted decimal
notation for example 255.255.255.0.
Enter the VLAN ID (Identifier) of the management (CPU) VLAN. You must connect to the
system through a port that is a member of the management (CPU) VLAN in order to
perform in-band management.
These fields configure out-of-band management settings. Out-of-band management
refers to accessing the management interface through a management port.
Enter the out-of-band management IPv4 address for the management port in dotted
decimal notation (for example 1.2.3.4).
Enter the out-of-band management IP subnet mask for the management port in dotted
decimal notation for example 255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Management Switch Card User's Guide