ZyXEL Communications MSC1000G User Manual page 556

Chapter 13 Switch Screens
Table 297 LLDP Port (continued)
LABEL
Chassis ID
Subtype
Port ID
Port ID
Subtype
Port
Description
System
Name
System
Description
System
Capability
Management
Address
Port VLAN ID
VLAN Name
Dot3 MAC/
PHY Conf
Dot3 Link
Aggregation
Dot3 Max
Frame Size
Apply
Cancel
Remote
Index
Remote
Chassis
Remote Port
ID
Time Mark
Tx Frames
Out
Rx Frames
Discard
Rx Frames
Errors
Rx Frames In
Total
Rx TLVs
Discard
556
DESCRIPTION
This tells what type of identifier is listed in the Chassis ID field (for example, MAC address).
This identifies the port on the MSC.
This tells what type of identifier is listed in the Port ID field.
Select this to include this port's description in LLDP frames sent out through it.
Select this to include the system name in LLDP frames sent out through this port.
Select this to include the system description in LLDP frames sent out through this port.
Select this to include information about the system's capabilities in LLDP frames sent out
through this port.
Select this to include the system's management IP address in LLDP frames sent out through
this port.
Select this to include this port's VLAN ID in LLDP frames sent out through it.
Select this to include this port's VLAN name in LLDP frames sent out through it.
Select this to include this port's duplex and speed capabilities and current settings in LLDP
frames sent out through it.
Details include whether or not auto negotiation is supported, the advertised port speed and
auto negotiation capabilities, and the operational Medium Attachment Unit (MAU) type such as
100BASE-TX full duplex mode. A MAU performs physical layer functions including injecting bits
into the network, converting digital data from the Ethernet interface, and collision detection.
Select this to include this port's current link aggregation settings in LLDP frames sent out
through it.
Select this to include this port's maximum frame size in LLDP frames sent out through it.
Click Apply to save the changes in this section to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to reset the fields.
This is the number of an entry in the list of connected remote devices learned through LLDP.
This is the number of a connected remote chassis learned through LLDP.
This is the number of the port on a remote chassis to which this port is connected.
This is when this entry in the list of connected remote devices was learned through LLDP.
This is how many LLDP frames the port has sent.
This is the number of LLDP frames received on this port that have been discarded due to
errors.
This is the number of errored LLDP frames received on this port.
This is the total number of LLDP frames received on this port.
This is the total number of discarded threshold limit values (TLVs) in LLDP frames received on
this port.
Management Switch Card User's Guide