Static Multicast Slot Screen - ZyXEL Communications MSC1000G User Manual

Table 79 Static Multicast (continued)
LABEL
Apply
New
Cancel
Modify
Delete
VID
Group IP
Port
Slot
Select

8.5.1 Static Multicast Slot Screen

Click Multicast > Static Multicast in the navigation panel to display the Static Multicast screen.
Type a VID and a group IP and click Apply to display entries in the first table. Click the slot number
of an active line card to open the following screen. Use this screen to set which of the line card's
ports belong to the static multicast group.
Figure 118 Static Multicast Slot
Management Switch Card User's Guide
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
After you click Apply, entries display in the first table so you can edit them. Click New if you
want to configure a different static multicast group.
Click Cancel to begin configuring the screen again.
Select a static multicast group's radio button and click Modify to display the static multicast
group in the table above so you can edit it.
Select a static multicast group's radio button and click Delete to remove the static multicast
group.
This is the number of the VLAN that this static multicast group uses.
This is the static multicast IP address.
This section lists the VLAN membership setting of the ports on the management switch card.
An "F" indicates that the port is a permanent member of the static multicast group. An "X"
indicates that the port is forbidden (blocked) from joining the static multicast group. An "-"
indicates that the port is a normal member and can join the VLAN dynamically. See
320 on page 593 for more on VLAN registration.
This section displays the numbers of any slots that are fixed members of the static multicast
group. All other slots are represented by a "-".
Select a static multicast group's radio button and then click Modify to be able to edit it or
click Delete to remove it.
Chapter 8 Multicast Screens
Table
195