Ipbpvc Vlan Setup Screen - ZyXEL Communications MSC1000G User Manual

Table 124 IPBPVC (continued)
LABEL
PVID
Profile
IPBPVC Type
Priority
Apply
Cancel
ID
State
Card Type
Up Time
Firmware

9.19.1 IPBPVC VLAN Setup Screen

Use this screen to configure a IPB PVC's VLAN settings.
To open this screen, click Port > IP Bridge > IPBPVC and then the index number of an IPB PVC.
Management Switch Card User's Guide
DESCRIPTION
Type the VLAN ID to assign to frames received on this channel. This VLAN ID must be in an IP
bridge domain.
Use the drop-down list box to select an ATM profile to use for this channel's traffic shaping.
Use the drop-down list box to specify the encapsulation type for the PVC.
llc and vc are for a PVC running on Ethernet (IPoE), llc_r and vc_r are for a PVC running on
ATM (IPoA).
Use the drop-down list box to select the priority value (0 to 7) to add to incoming frames
without a (IEEE 802.1p) priority tag.
Click Apply to add or save channel settings on the selected port.
Clicking Apply saves your changes to the MSC's volatile memory. The MSC loses these
changes if it is turned off or loses power, so use the Config Save link on the navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
This is the slot number of a line card. Click the index number of an active line card that
supports PVC to display a list of the IPB PVCs on the selected line card (see
page 276).
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to
the card starting, a firmware upgrade in progress or a malfunction. See
1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was started.
This field displays the current firmware version installed on the line card.
Chapter 9 Subscriber Port Setup Screens
Section 9.19.2 on
Section 38.7 on page
275