ZyXEL Communications MSC1000G User Manual page 563

Figure 387 Access Control: SNMP
The following table describes the labels in this screen.
Table 300 Access Control: SNMP
LABEL
Get Community
Set Community
Trap Community
Version
Trap Destination
Version
Management Switch Card User's Guide
DESCRIPTION
Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station. You can use up to 31 English keyboard
characters; spaces are not allowed.
Enter the set community, which is the password for incoming Set- requests from the
management station. You can use up to 31 English keyboard characters; spaces are not
allowed.
Enter the trap community, which is the password sent with each trap to the SNMP
manager. You can use up to 31 English keyboard characters; spaces are not allowed.
Specify the SNMP version and access mode.
Select v2c to allow SNMPv2 read/write access.
Select v3 to allow SNMPv3 read/write access with additional user authentication and data
encryption options.
Select v3v2c to allow SNMPv3 read/write and SNMPv2 read-only access.
Enter the IP address of a station to send your SNMP traps to.
Specify the format of the SNMP trap PDU (Protocol Data Unit) to be sent. The default is
v2c.
Chapter 14 Sys Screens
563