ZyXEL Communications MSC1000G User Manual page 405

The following table describes the labels in this screen.
Table 187 ACL Profile Setup
LABEL
Name
Rule
ethernet type
vlan
source mac
dest mac
priority
protocol or
protocol type
source ip
dest ip
tos
src port
dest port
Action
rate
replaced vlan
replaced priority
deny
Apply
New
Cancel
Index
Name
Select
Modify
Delete
Management Switch Card User's Guide
DESCRIPTION
Enter a descriptive name for the ACL profile. The name can be 1-31 printable ASCII
characters long. Spaces are not allowed.
Select which type of rule to use.
Note: The lower the number (1-14), the higher the priority the rule has.
Provide additional information required for the selected rule. Additional rules consist of
one or more of the following criteria.
Enter the 16-bit EtherType value between 0 and 65535.
Enter a VLAN ID between 1 and 4094.
Enter the source MAC address.
Enter the destination MAC address.
Select the IEEE 802.1p priority (0~7).
Select the IP protocol (tcp, tcp6, udp, udp6, ospf, igmp, ip, gre or icmp) to use
from the drop-down list box or select "-" and specify an IP protocol number (between 0
and 255) to use.
Enter the source IPv4 address and subnet mask in dotted decimal notation or IPv6
address and prefix in colon hexadecimal notation.
Enter the destination IPv4 address and subnet mask in dotted decimal notation or IPv6
address and prefix in colon hexadecimal notation.
Enter the start and end Type of Service between 0 and 255. If you want to specify a
single ToS, enter it as both the start and the end.
Enter the type of traffic (tcp, tcp6, udp, udp6) or the source listening port.
Enter the type of traffic (tcp, tcp6, udp, udp6) or the source listening port.
Select which action(s) the system should take when the criteria are satisfied.
Enter the maximum bandwidth this traffic is allowed to have.
Enter the VLAN ID that this traffic should use.
Select the IEEE 802.1p priority (0~7) that this traffic should have.
Select this if you want the system to reject this kind of traffic.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
link on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh profile
without saving your changes.
Click Cancel to start configuring the screen again.
This is an incremental number indicating the order in which the profiles were created.
This is the name of the profile.
Select the profile you wish to load or delete.
Select a profile and click this in order to edit its configuration.
Select a profile and click this to delete the profile. Once deleted, information cannot be
retrieved.
Chapter 11 Profile Screens
405