Ipb Route Screen - ZyXEL Communications MSC1000G User Manual

To open this screen, click Port > IP Bridge > IPBPVC and then the index number of an active line
card that supports PVC.
Figure 176 IPBPVC: Slot
The following table describes the labels in this screen.
Table 126 IPBPVC: Slot
LABEL
UP
Delete, Select
Index
Port
VPI/VCI
Profile
Type
IPBPVC
PVID
Priority
Select

9.20 IPB Route Screen

Use this screen to set up and maintain the routing table for each domain. Each routing table
contains entries that, based on the destination IP address, control where the MSC forwards
packets. The MSC automatically creates routing table entries for each downlink interface and for
each edge router in the domain that the associated VLAN is in. You can create additional entries by
specifying the edge router to which the MSC should forward traffic for a particular destination IP
address or IP subnet.
To open this screen, click Port > IP Bridge > Route.
Management Switch Card User's Guide
DESCRIPTION
Click UP to go back to the previous screen.
Select an entry's Select check box and click Delete to remove the entry.
This field displays the index number of a IPB PVC on this slot. Click the index number to go
to a screen where you can configure the IPB PVC's VLAN settings (see
page 275).
This field displays the port number of a port on this line card that has an IPB PVC.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI). The VPI
and VCI identify a IPB PVC (a channel).
This shows which ATM profile this channel uses.
This field displays IPB to indicate that this is an IPB PVC.
llc and vc are for a PVC running on Ethernet (IPoE), llc_r and vc_r are for a PVC running on
ATM (IPoA).
This is the VLAN ID assigned to frames received on this channel.
This is the priority value (0 to 7) added to incoming frames without a (IEEE 802.1p) priority
tag.
Select the radio button in the Select column for an entry and click Delete to remove the
entry.
Chapter 9 Subscriber Port Setup Screens
Section 9.19.1 on
277