Table 148 IMA Group Setup (continued)
LABEL
Apply
Cancel
ID
State
Card Type
Up Time
Firmware
10.5 The PVC Setup Screen
Click IMA > PVC in the navigation panel to open the following screen. Use this screen to configure
PVC settings used by an IMA line card for mapping a single-tagged frame with a PVC (channel).
Figure 210 PVC Setup
Management Switch Card User's Guide
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
This column lists the slot numbers of the line cards. Click the ID number of an active DSL
line card to go to a screen where you can view and delete PVCs from the line card's DSL
ports.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
page 1111
for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
Chapter 10 IMA Screens
Section 38.7 on
319