Port Mirroring Setup - ZyXEL Communications MSC1000G User Manual

Chapter 13 Switch Screens
Figure 381 Switch > SFP
The following table describes the labels in this screen.
Table 294 Switch > SFP
LABEL
Port
High Limit
Low Limit
Temperature
Supply
Voltage
TX Bias
Tx Power
Rx Power
Apply
Cancel

13.22 Port Mirroring Setup

Port mirroring allows you to copy an MSC uplink port's traffic flow to a monitor port so you can
examine the traffic without interfering with the original port's traffic flow.
Click Switch > Mirror in the navigation panel to display the Mirroring screen. Use this screen to
select a monitor port and specify the traffic flow to be copied to the monitor port.
550
DESCRIPTION
Select an Ethernet SFP slot and click Load to edit its settings.
Use these fields to set the related measurement's high and low thresholds. The system issues a
Threshold Crossed Alarm (TCA) when it detects one of the thresholds being crossed. By default
the maximum values display in the High Limit fields and the minimum values display in the
Low Limit fields.
Set the maximum and minimum SFP module temperature thresholds in degrees Celsius.
Set the maximum and minimum levels of voltage in volts that can be supplied to the SFP
module.
Set the maximum and minimum current in milliamps (mA) that can be supplied to the SFP
module's Laser Diode Transmitter.
Set the maximum and minimum number of micro Watts (uW) of light the SFP module can
transmit.
Set the maximum and minimum number of micro Watts (uW) of light the SFP module can
receive from the fiber optic cable.
Click Apply to save the changes in this section to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to reset the fields.
Management Switch Card User's Guide