Enet Port Setup - ZyXEL Communications MSC1000G User Manual

Table 134 The Advanced H248 Port Setup Screen
LABEL
Termination
Impedance
Apply
Cancel

9.28 ENET Port Setup

Click Port > Enet in to open the following screen. Use this screen to configure settings for
individual subscriber Ethernet or Gigabit Ethernet ports.
Figure 191 ENET Port Setup
Management Switch Card User's Guide
DESCRIPTION
Enter the name for this port's H.248 Termination. By default, the port's Termination
name is "termX", where X is the port number. Enter up to 31 alphanumeric
characters. Spaces are not allowed.
This field displays the default VoIP port AC impedance. The default impedance value
depends on the country code (configured in the VoIP > Countrycode screen).
If you do not want to use the default impedance, select the required AC impedance of
the VoIP port from the drop-down list.
Click this to save your changes to the MSC's volatile memory. The MSC loses these
changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click this to begin configuring the fields again.
Chapter 9 Subscriber Port Setup Screens
295