ZyXEL Communications MSC1000G User Manual page 862

Chapter 30 profile Commands
Table 366 profile Commands (continued)
COMMAND
set
show
dialplan
delete
dialplan
map
dialplan
set
862
<profile> <sip-dn> <regsvr-
ip>|<regsvr-dn> <proxysvr-
ip>|<proxysvr-dn> [sipport
<sip-port>]
[regsvrport <regsvr-port>]
[proxysvrport <proxysvr-
port>] [dscp <dscp>]
[keepalive off|on <se>]
[switchtype <switchtype>]
[rtpport <start-rtp-port>
<end-rtp-port>]
[<profile>]
<profile>
<profile>
<profile> <index>
[<dialplan-table>]
DESCRIPTION
Configures the specified SIP profile. The system
supports up to 128 SIP profiles.
sip-dn: The SIP server's domain name
(maximum 63 characters).
regsvr-ip: SIP registrar server's IP address.
regsvr-dn: registrar server's domain name, up to
63 characters.
sip-port: SIP UA port number (1025 ~ 65535).
regsvr-port: SIP registrar server's port number
(1025 ~ 65535).
proxysvr-ip: SIP proxy server's IP address.
proxsvr-port: SIP proxy server's port number
(1025 ~ 65535).
dscp: DSCP for RTP, SIP packets (0 ~63).
keepalive: Enable (on) or disable (off) the SIP
session keepalive. When enabled, the SIP UA
periodically sends SIP session refresh requests.
se: The minimum session expiration time (90 ~
65535 seconds).
switchtype: Select the switch type for the NGN
server:
1: Call transfer
2: Inquiry call
3: Broker call
4: Waiting call
5: Conference call
rtpport: Set a range of RTP (Real time Transport
Protocol) ports to use for voice data transfer.
start-rtp-port: Start of RTP port number,
should be even, 4000~64000.
end-rtp-port: End of RTP port number, should
be even, 5000~65535.
Displays the current settings of the specified
profile, or displays the names of all profiles if
none is specified.
Removes the specified dial plan profile.
Displays subscribers referenced by all dial
plan profiles or by the specified one.
Configure dial plan related settings of the
specified profile.
<index>: The index number for an entry in
the dial plan table (1~32).
<dialplan-table>: The dialplan table
name (<=31 characters). Use the voip
dialplan set command to set up a
dialplan.
Management Switch Card User's Guide
P
8
1
8
1
8