Ipb Interface Screen - ZyXEL Communications MSC1000G User Manual

The following table describes the labels in this screen.
Table 122 IPB Edgerouter
LABEL
Edgerouter IP
NetMask
VID
Apply
New
Cancel
Index
Domain
Edgerouter IP
NetMask
VID
Select
Modify
Delete
Page X of X
Previous/Next

9.18 IPB Interface Screen

Use this screen to set up and maintain forwarding information for downstream traffic. The MSC
learns some of this information by snooping DHCP packets. For static IP addresses, you should
provide this information manually. Downlink interfaces in the same domain cannot have
overlapping IP addresses.
To open this screen, click Port > IP Bridge > Interface.
See Section 12.8 on page 421
traffic, whether learned by snooping DHCP packets or provided manually.
Management Switch Card User's Guide
DESCRIPTION
Enter the IP address of the edge router.
Enter the number of bits in the subnet mask of the edge router.
Enter the ID of the VLAN of which the edge router is a member. The MSC uses this VLAN ID
when it forwards frames to the edge router. It also uses the VLAN ID to identify the domain
the edge router is in. You have to add the VLAN ID to an IP bridge domain before you can
enter it here.
Click Apply to create the edge router setting. It is then displayed in the summary table at
the bottom of the screen.
Clicking Apply saves your changes to the MSC's volatile memory. The MSC loses these
changes if it is turned off or loses power, so use the Config Save link on the navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click New to set the screen to configure a new entry.
Click Cancel to start configuring this section of the screen again.
This field displays the number of the edge router.
This field displays the name of the domain to which the edge router belongs.
This field displays the IP address of the edge router.
This field displays the number of bits in the subnet mask of the edge router.
This field displays the VLAN ID of the edge router.
Select the radio button in the Select column for an entry and click Modify to be able to edit
the entry or Delete to remove it.
This identifies which page of information is displayed and the total number of pages of
information.
Click one of these buttons to show the preceding/following screen if the information cannot
be displayed in one screen.
for how to display all the forwarding information for downstream
Chapter 9 Subscriber Port Setup Screens
271