34.4.7 sys snmp version Command
Syntax:
sys snmp version v2c|v3|v3v2c
where
v2c|v3|v3v2c
This command sets the system to use the specified SNMP version and access mode.
The following example configures the system to use SNMPv3 with read-only access for SNMPv2.
ras> sys snmp version v3v2c
34.5 sys syslog Commands
Use these commands to configure the system's syslog settings.
34.5.1 sys syslog server Command
Syntax:
sys syslog server <fac> <ip-address>
where
<fac>
<ip-address> =
This command sets the syslog server's IP address and log facility.
The following example sets a syslog server log facility of 3 and IP address of 192.168.1.43.
ras> sys syslog server local3 192.168.1.43
Management Switch Card User's Guide
=
Sets the SNMP version and access mode.
: SNMPv2 read/write
v2c
: SNMPv3 read/write with additional user authentication and data
v3
encryption options.
: SNMPv3 read/write and SNMPv2 read-only.
v3v2c
=
Sets the log facility (local1~local7) to log the syslog messages to a specific file
in the syslog server. See your syslog program's documentation for details. Sets
the syslog server IP address.
The IP address of the syslog server.
Chapter 34 sys Commands
1055