Enet Port Setup Line Card Screen - ZyXEL Communications MSC1000G User Manual

Table 135 ENET Port Setup (continued)
LABEL
Cancel
Copy
ID
State
Card Type
Up Time
Firmware

9.28.1 ENET Port Setup Line Card Screen

Click Port > ENET in the navigation panel to open the ENET Port Setup screen. Click the slot
number of an active Ethernet line card to open the following screen. Use this screen to configure
settings for individual Ethernet ports and copy settings between ports.
Management Switch Card User's Guide
DESCRIPTION
Click Cancel to begin configuring the screen again.
Do the following to copy settings from one subscriber port to another subscriber port or
ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the number
of the port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 192 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this screen.
Click Cancel to close the screen without saving changes.
This column lists the slot numbers of the line cards. Click the ID number of an active line
card to go to a screen where you can copy port settings to another port.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
page 1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
Chapter 9 Subscriber Port Setup Screens
Section 38.7 on
297