Switch Port Flowctrl Disable Command - ZyXEL Communications MSC1000G User Manual

Chapter 33 switch Commands
This command turns on data transmission on a Gigabit Ethernet interface.
The following example turns on the subtending 1 Gigabit Ethernet interface.
ras> switch port enable sub1

33.14.3 switch port flowctrl disable Command

Syntax:
switch port flowctrl disable <giga-port>
This command turns off flow control on a Gigabit Ethernet interface.
The following example turns off the flow control on the subtending 1 Gigabit Ethernet interface.
ras> switch port flowctrl disable sub1
33.14.4 switch port flowctrl enable Command
Syntax:
switch port flowctrl enable <giga-port>
This command turns on flow control on a Gigabit Ethernet interface.
The following example turns on the flow control on the subtending 1 Gigabit Ethernet interface.
ras> switch port flowctrl enable sub1
33.14.5 switch port frametype Command
Syntax:
switch port frametype <giga-port> all|tag
where
all|tag =
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports the subtending 1 Gigabit Ethernet interface to accept only tagged
frames.
ras switch port frametype sub1 tag
1022
Specifies all Ethernet frames (tagged and untagged) or only tagged Ethernet
frames.
Management Switch Card User's Guide