Chapter 11 Profile Screens
N-wire mode can increase the reach of a particular data rate without having to regenerate the
signal. It can also give increased bandwidth for LAN-to-LAN applications.
You can n-wire bundle multiple groups of ports on a single SHDSL line card.
11.10 SHDSL Profile Screen
Click Profile > SHDSL in the navigation panel to open the following screen. Use this screen to
configure SHDSL profiles. Later you can apply the SHDSL profiles to configure SHDSL ports in the
SHDSL Port Setup screens.
Figure 229 SHDSL Profile
The following table describes the fields in this screen.
Table 168 SHDSL Profile
LABEL
The top part of the screen is for profile configuration.
Name
Max Rate
[192~5696]
kbps
Min Rate
[192~5696]
kbps
Annex Mode
358
DESCRIPTION
When editing a profile, this is the name of this profile. When adding a profile, type a name
(up to 31 characters) for the profile.
Type a maximum transfer rate for this profile.
Type the minimum upstream transfer rate for this profile. The SHDSL connection will not
come up if you set this higher than the lowest speed the link can reach.
Select the region setting.
Select ANNEX_A to use DSL over POTS.
Select ANNEX_B to use DSL over ISDN.
Management Switch Card User's Guide