Switch Setup Vlanpri Screen - ZyXEL Communications MSC1000G User Manual

13.10 Switch Setup VlanPri Screen

Click Switch > Switch Setup > VlanPri to display the screen as shown. Use this screen to
overwrite the IEEE 802.1p priority value of traffic received through the Gigabit Ethernet interfaces
based on its VLAN ID.
Figure 355 Switch Setup VlanPri
The following table describes the labels in this screen.
Table 275 Switch Setup VlanPri
LABEL
Vlan Priority
Enable
Apply
Cancel
Add Vlan
Priority
Apply
Index
VLAN ID
Priority
Select
Management Switch Card User's Guide
DESCRIPTION
Select this to overwrite the IEEE 802.1p priority value of traffic received through the Gigabit
Ethernet interfaces based on its VLAN ID.
Click Apply to save the changes in this section of the screen to the system's volatile
memory. The system loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel and then the Save button to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Specify a VLAN ID and the IEEE 802.1p priority (0~7) to use for its downstream traffic. This
applies to traffic received through the Gigabit Ethernet interfaces.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
This is the entry's number in the list.
This is the VLAN ID to which the entry applies.
This is the priority the entry uses for downstream traffic with the specified VLAN ID.
Select the Select check box for any entries you want to remove and click Delete to remove
them.
Clicking Delete saves your changes to the MSC's volatile memory.
The MSC loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Chapter 13 Switch Screens
521