Switch Port Setup 802.1P/1Q Screen - ZyXEL Communications MSC1000G User Manual

13.15 Switch Port Setup 802.1P/1Q Screen

Click Switch > Switch Port Setup > 802.1P/1Q in the navigation panel to display the screen
shown next. Use this screen to configure IEEE 802.1p priority and IEEE 802.1Q VLAN settings for
the Gigabit Ethernet interfaces.
Figure 368 Switch Port Setup: 802.1P/1Q
The following table describes the labels in this screen.
Table 282 Switch Port Setup: 802.1P/1Q
LABEL
Port
Default Priority
Default VLAN ID
[1-4094]
GVRP
Frame Type
VLAN Trunk
Apply
Cancel
Management Switch Card User's Guide
DESCRIPTION
This is the label of a Gigabit Ethernet interface.
Select a default priority to use for frames that come into the interface without a IEEE
802.1p priority tag.
Select a default VLAN ID to use for frames that come into the interface without a IEEE
802.1Q VLAN ID.
Select this check box to turn on GARP VLAN Registration Protocol to have the interface
propagate VLAN information to other devices.
Clear the check box to not have the interface propagate VLAN information to other
devices.
Select all to have the interface accept all Ethernet frames. Select tag to have the
interface only accept frames with an IEEE 802.1Q VLAN tag.
Select this check box to have the interface use VLAN trunking in order to accept frames
with any VID.
Clear the check box to have the interface only accept frames with registered VIDs.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 13 Switch Screens
535